BOMANN 721942 Instruction Manual page 22

NOTE:
Installation of the rubber supporting pad is ONLY
necessary if the interior is empty and the refrigerator
door is loaded with 15 kg or more.
Tilt the appliance slightly back and block it in this
position. Use the delivered screw to secure the sup-
porting pad into the hole provided on the underside
of the door.
Leveling the appliance
Slight unevenness in the floor can be leveled out
using the front feet.
Check whether the appliance is leveled horizontally.
If the appliance is not in balance, the feet must be
adjusted.
Electrical connection
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reversing the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Loosen the screws on the appliance back and
remove the appliance cover.
• Dismount the upper door hinge and the screws
(s). Lift the appliance door and set it safely aside.
• Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet and disassemble
the lower door hinge.
22
screw wrench, Phillips screw-