Table of Contents
Advertisement
AXIS F9114 Main Unit
Configure your device
Note
If you update the overlay text it will be automatically updated on all video streams dynamically.
Record video when the camera detects loud noises
This example explains how to set up the camera to start recording to the SD card five seconds before it detects loud noise and
to stop two minutes after.
Note
The following instructions require that a microphone is connected to audio-in.
Turn on audio:
1. Set up the stream profile to include audio, see Add audio to your recording on page 14.
Turn on audio detection:
1. Go to System > Detectors > Audio detection.
2. Adjust the sound level according to your needs.
Create a rule:
1. Go to System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under Audio, select Audio Detection.
4. In the list of actions, under Recordings, select Record video.
5. In the list of storage options, select SD_DISK.
6. Select the stream profile where audio has been turned on.
7. Set the prebuffer time to 5 seconds.
8. Set the postbuffer time to 2 minutes.
9. Click Save.
Set up the intrusion alarm
Before you start
•
Connect the intrusion alarm switch to pin 1 (ground) and pin 3 (digital I/O) of the camera's I/O connector.
Configure the input port
1. Go to System > Accessories > I/O ports.
2. For Port 1:
2.1 Select Input.
2.2 Select Circuit closed.
Add a recipient:
3. Go to System > Events > Recipients and click Add recipient.
4. Type a name for the recipient.
5. Select Email.
12
Advertisement
Table of Contents
