Set The Time, Date & Units - AcuRite 01128HD Instruction Manual

Set the Time, Date and Units
Press and hold the "SET" button, located on the front of the display, to enter SET MODE.
Once in set mode, the preference you are currently setting will blink on the display.
To adjust the currently selected (flashing) item, press and release the " " or
" " buttons (press and HOLD to fast adjust).
To save your adjustments, press and release the "SET" button again to adjust the next
preference. The preference set order is as follows:
Auto DST (Daylight Saving Time
CLOCK HOUR
CLOCK MINUTE
CALENDAR MONTH
CALENDAR DATE
CALENDAR YEAR
TEMPERATURE UNITS (˚C or ˚F)
*If you live in an area that observes DST, DST should be set to ON, even if it is not currently
Daylight Saving Time.
You will automatically exit SET MODE if no buttons are pressed for 8 seconds. Enter setup
mode at any time by pressing the " SET " button.
Placement for Maximum Accuracy
AcuRite sensors are sensitive to surrounding environmental conditions. Proper placement
of both the display and outdoor sensor are critical to the accuracy and performance of this
product.
Display Placement
Place the display in a dry area free of dirt and dust. Display stands upright for
tabletop use or is wall-mountable.
Outdoor Sensor Placement
Sensor must be placed outside to observe outdoor conditions. Sensor is water
resistant and is designed for general outdoor use, however, to extend its life
place the sensor in an area protected from direct weather elements.
Hang the sensor using the integrated hang holes or hanger, or by using string
(not included) to hang it from a suitable location, like a well covered tree
branch. The best location is 4 to 8 feet above the ground with permanent shade
and plenty of fresh air to circulate around the sensor.
ON of OFF)*
5