Advertisement
Quick Links
Note: Infrared Programmer QuickSet Pro required for commissioning
Honeywell Ex-Or
Albery House, Springfield Road,
Horsham, West Sussex RH12 2PQ
Tel: +44 (0)1942 719229
Fax: +44 (0)1942 508753
Email: technicalsales.ex-or@honeywell.com
www.ex-or.com
by Honeywell
Silver Series LightSpot with photocell
MS1221PF / MS1221PSM
MS1221PF
Installation and Commissioning
Instructions
MS1221PSM
At the end of their useful life
the packaging and product
should be disposed of via a
suitable recycling centre.
Do not dispose of with normal
household waste.
Do not burn.
W4231I
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Honeywell Ex-Or LightSpot Silver Series
Summary of Contents for Honeywell Ex-Or LightSpot Silver Series
- Page 1 Honeywell Silver Series LightSpot with photocell MS1221PF / MS1221PSM MS1221PF MS1221PSM Installation and Commissioning Instructions Note: Infrared Programmer QuickSet Pro required for commissioning Honeywell Ex-Or Albery House, Springfield Road, At the end of their useful life Horsham, West Sussex RH12 2PQ...
- Page 2 Silver Series LightSpot with photocell The Silver Series LightSpot is a high performance presence detector with photocell. In all operating modes, the photocell can hold lights off as a vacant area becomes occupied, and if the light level falls too low during the period of occupancy, the lights switch on.
- Page 3 Parameter Options R1 and R2 Off Delay Independent Off Delays of between 1 minute and 96 hours may be set for each Relay. A 10-second Off Delay is available for walk-testing the product. In a typical office environment a 20-minute Off Delay is usually satisfactory. Response (Automatic / Semi-Automatic) Where absence detection is required (i.e.
- Page 4 Setting the Photocell (Photocell only affects the ‘Live Out’ output) If the lights are not already on, switch them on manually by pressing ‘Utilities / LightSpot/MLS/LCM / IR Remote / Luminaire+ / OK’ on the QuickSet Pro. Fluorescent lights do not reach full output until up to 15 minutes after being switched on, so ensure that the lights are fully warmed up before continuing.
Need help?
Do you have a question about the Ex-Or LightSpot Silver Series and is the answer not in the manual?
Questions and answers