Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Faro MP3020
Summary of Contents for Faro MP3020
-
Page 2: Table Of Contents
2.3.3 Remote Cable connection..........................5 2.3.4 Auto-on setting .............................5 COMPLETE LIGHT CONNECTION TO THE CEILING ................. 6 2.4.1 Ceiling mounting with Faro applications ....................6 2.4.2 Installation procedure ..........................7 2.4.3 Electrical drawing – ceiling mounting with transformer ..............8 2.4.4 Electrical drawing – ceiling mounting without transformer ............9 WALL MOUNTING ............................ -
Page 3: Symbols Used
The device must never be modified without written authorization of FARO S.p.A. For maintenance only original FARO’s spare parts are allowed. Fail to comply with this warning will immediately make decay the warranty and the conformity of the product to international regulations and directives on Medical Devices. -
Page 4: Dimensions
Lubricating grease must be applied to the surface of the post before the connection is done. Faro suggests the following grease to be applied: Molykote 111 silicon Grease. With a digital level, ensure the connection element on the unit is perfectly parallel to the ground (max 2°) -
Page 5: Power Supply Connection
MP3020 INSTALLATION MANUAL - EN Take care that the fixed arm is parallel to ground in each position. Check the light stays balanced in all positions and no drifting of the swivel arm occurs. If necessary, adjust the force on the spring by screwing or unscrewing the nut (B) with the suitable tool until the arm is balanced. -
Page 6: Complete Light Connection To The Ceiling
Warnings for electrical danger and suspended masses - The device has to be installed by specialized technicians only - The light has to be installed with FARO applications only. - The light is supplied with rotation limit switch between the fixed and the swivel arm. -
Page 7: Installation Procedure
MP3020 INSTALLATION MANUAL - EN 2.4.2 Installation procedure A After having fixed as reference point the centre of the chair (A). install at a distance of 650mm and 150mm, according to the directions given in the picture. B. Unfit the flange (7) by removing the nuts (12) and washers (11). -
Page 8: Electrical Drawing - Ceiling Mounting With Transformer
MP3020 INSTALLATION MANUAL - EN N. Screw (without locking) the nuts (12) O. Unscrew the three screws (19) of the column (14) and remove the bushing and the remaining (20) washers (11) on the screws (8) of the ceiling flange (1) P. -
Page 9: Electrical Drawing - Ceiling Mounting Without Transformer
MP3020 INSTALLATION MANUAL - EN 2.4.4 Electrical drawing – ceiling mounting without transformer WALL MOUNTING Warnings for electrical danger and fall of suspended masses The device must be installed by specialized tecnicians The power supply in the room where the fitting must be installed must be always switched off. -
Page 10: Electrical Drawing - Wall Mounting Without Transformer
MP3020 INSTALLATION MANUAL - EN Connect the lamp wires to the terminal Electrical connector (5) (see wiring diagram below) including the grounding wire. Connect wires coming wall terminal board, case been previously walled absence this precaution, connection it must be carried out with an external flying cable, to be introduced into the cable gland (10). -
Page 11: Electrical Drawing - Floor Mounting Without Transformer
Warning for danger of suspended mass falling Only use screws supplied by FARO. Screw in the safety screws together. Before removing the nut (G) ALWAYS remove the safety screw F. NEVER unscrew the nut (G) with the screws F mounted. -
Page 12: Electrical Requirements
MP3020 INSTALLATION MANUAL - EN 2.8.2 Electrical Requirements The requirements for correct installation of the head are as follows: Power Supply Supply cables Power Supply requirements Type Conformity Device 60601-1 17-24 Vac Transformer complies with IEC/EN 60601- Component The medical 50/60 Hz 1 third edition.
Need help?
Do you have a question about the MP3020 and is the answer not in the manual?
Questions and answers