Yamaha TG77 Installation Manual page 13

Yamaha TG77 LCD Replacement Guide
Fig. 13 - Included 2-pin Connector soldered into CN605 Position
Step 5:
Once the CN605 2-pin wired connector is desoldered and removed, the
included white 2-pin connector needs to be soldered in its place as
shown in Fig. 13 above. Be sure to correctly orient the connector as
shown, with the slots facing the edge of the board.
Once the 2-pin connector is properly soldered into place, reinstall the
power supply circuit board and screw it back into place, also reattach
the power switch button.
13
produced by: glitchscience.com
2022©