Table of Contents
Advertisement
OVERVIEW
LED Display
Bluetooth Connection Indication
Resting Heart Rate Result
6
Pound
Kilogram
INITIAL START-UP
General Instructions
Kinetik Wellbeing's Smart Body Analyser Scale BTS200 applies BIA (Bio-impedance
Analysis) technology. A small amount of weak current flows through the human
body so as to detect the bio-impedance and estimate body fat and heart rate. The
electrical current is small and may not be felt.
This BIA technology is cheap, safe, non-invasive, toxic-free and harmless. It also
possesses the characteristics of simple operation and abundant information.
The current mentioned above is less than 0.5mA. However, please be aware that
anyone with an wearable or implantable medical electronic instrument, such as a
pacemaker, must avoid using this device.
The intended use of this device is for healthy children 10-17 years old and healthy
adults.
Insert the Batteries
Open the battery door in the back of the scale.
Insert the batteries (4 x 1.5V AAA) into the
battery compartment according to the polarity
indications marked inside the compartment.
* The digits " 8888 " will be shown on the LED.
Close the battery door, the scale is initialized
when the digits "ZEro" are shown. Place the
scale on the ground and wait, "000.0" lb will
be shown.
* The scale will shut down in 30s without measurement.
CAUTION
When the symbol " Lo" appears, you shall replace with a new set of batteries. Please replace all four
batteries at the same time. Do NOT mix the old batteries with the new one.
Worn batteries are hazardous waste. Do NOT dispose of them together with the household garbage.
Please refer to the local ordinances and recycling instructions regarding disposal of the worn batteries
and scrapped device.
If you do not intend to use this unit for a prolonged period of time, it is advisable to remove the batteries
before storing.
Do not mix alkaline, standard(carbon-zinc), or rechargeable(Ni-Cd, Ni-MH, etc) batteries.
7
Advertisement
Table of Contents
