Table of Contents
Advertisement
High speed causes increased air resis-
•
tance.
Fuel quality, road and traffic conditions,
•
weather and the condition of the car.
A combination of the examples above could
increase consumption considerably.
There may be huge deviations in fuel con-
sumption if comparing to the drive cycle pro-
files (see below), which are used in the certifi-
cation of the car and on which consumption
figures in the table are based. For further infor-
mation, please refer to the referenced regula-
tions.
NOTE
Extreme weather conditions, driving with a
trailer or driving at high altitudes, in combi-
nation with poorer fuel quality than recom-
mended, are factors that considerably
increase the car's fuel consumption.
WLTP standard
From and including 1 September 2018, a new
standard was introduced for calculating con-
sumption values in the car. The WLTP stand-
ard (Worldwide Harmonised Light-Duty Vehi-
cles Test Procedure) represents the average
driving conditions for everyday driving. In
comparison with the previous standard
(NEDC), WLTP takes into account more varied
traffic situations and speeds, but also equip-
ment and weight classes. Optional equipment
that affects consumption is deactivated during
testing, e.g. air conditioning, seat heating, etc.
The new standard should provide more realis-
tic figures when it comes to fuel consumption,
carbon dioxide and emissions. The values are
intended to allow comparison between differ-
ent cars and not to represent your typical nor-
mal consumption.
Drive cycle profiles
A drive cycle simulates actual average driving
of the car. The standard is based on four differ-
ent drive cycle profiles. The four drive cycle
profiles are:
Urban driving – slow driving
•
Suburban driving – average driving
•
Extra-urban driving – fast driving
•
Motorway driving – very fast driving.
•
Every drive cycle is determined by different
conditions such as speed, time and mileage,
for example.
The official value for combined driving, which
is shown in the table, is a combination of the
results from the four drive cycles, in accord-
ance with legal requirements.
The exhaust gases are collected in order to
extrapolate the carbon dioxide emissions (CO
emissions) during the four drive cycles. These
were then analysed to determine the value for
CO
emissions.
2
Related information
Type designations (p. 670)
•
Weights (p. 675)
•
Economical driving (p. 466)
•
2
SPECIFICATIONS
689
Advertisement
Table of Contents
