Advertisement
IMPORTANT: Read all instructions and warnings carefully before installation
and use. Failure to follow these instructions may result in a possible electric
shock, injury to persons, fire hazard and will void the warranty.
OPERATING INSTRUCTIONS
Note: When using the heater for the first time, you may notice a slight emission of smoke.
This is normal and will stop after a short time. The heating element is made of steel and
was coated with a layer of protective oil during production.
Setting
1. Position the fan heater so that it stands on a firm level surface (When
used as portable) and at a safe distance from wet locations and flammable
objects.
2. Connect the fan heater to the proper electrical power. See grounding
instructions.
3. Set the power settings knob to fan or heating Position.
4. Set the thermostat dial to the maximum temperature.
5. Once the room reaches the desired temperature, turn the thermostat dial
back until heating element turns off. The heater will cycle automatically
around this present temperature. To increase temperature, turn the
thermostat knob clockwise. To lower temperature, turn the thermostat
counterclockwise.
Electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electrical shock and injury
to persons.
SAVE THESE INSTRUCTIONS
Function
Unit is Off
Fan Runs - No Heat
Fan Runs - Half Power Heat
Fan Runs - Full Power Heat
[4]
Advertisement
