Alcove Or Closet Installation - GE Electric Dryer 02 Installation Instructions Manual

without kinking and or crushing the transition duct,
• Avoid resting the duct on sharp objects.
UL-LISTED FLEXIBLE METAL (FOIL-TYPE) TRANSITION DUCT
• In special installations, it may be necessary to connect
diameter can be maintained throughout the entire length
of the transition duct.
other enclosed spaces.
• Avoid resting the duct on sharp objects.
Installation Instructions
For best drying performance
pipe.
2. Secure the duct with a clamp.
to its full length. Allow 2" of duct to overlap the exhaust
4. Secure the duct to the exhaust pipe with the other clamp.
LEVELING AND STABILIZING YOUR
5
DRYER
the 4 leveling legs, at the corners, to ensure that the dryer
is level from side to side and front to rear.
LEVEL
FRONT-TO-BACK
4 LEVELING
LEGS

ALCOVE OR CLOSET INSTALLATION

6
• If your dryer is approved for installation in an alcove or
closet, it will be stated on a label on the dryer back.
• The dryer MUST be vented to the outdoors. See the
EXHAUST INFORMATION
• Minimum clearance between dryer cabinet and adjacent
• Closet doors must be louvered or otherwise ventilated
equally distributed. If the closet contains both a washer
of open area equally distributed.
NOTE: WHEN THE EXHAUST DUCT IS LOCATED AT THE REAR OF
THE DRYER, MINIMUM CLEARANCE FROM THE WALL IS 5.5 in.
6
LEVEL
SIDE-TO-SIDE