Table of Contents
Advertisement
30105868GB.fm Page 10 Monday, May 8, 2006 6:15 PM
Where to put detergent and additives
The detergent drawer has three chambers (fig. "A").
Prewash Chamber
• Detergent for the prewash
Main Wash Chamber
• Detergent for the main wash
• Stain remover
• Water softener (water hardness class 4)
Softener Chamber
• Fabric softener
• Liquid starch
Pour additives only up to the "MAX" mark.
Using chlorine bleach
• Wash your laundry in the desired programme (Cotton, Synthetics),
adding an appropriate amount of chlorine bleach to the SOFTENER
chamber (close the detergent dispenser carefully).
• Immediately after end of programme, start the "Rinse and Spin"
programme to eliminate any residual bleach smell; if you want,
you can add softener.
Never put both chlorine bleach and softener into the softener
chamber at the same time.
How to position the separator in the main wash
chamber for powder or liquid detergent
For use with powder detergent: place the separator in the higher
position.
Lift the separator until its top can be reclined. Place its hooks on the
upper end of the back guide rails and slightly push the separator
down to fix it (fig. "B" and "C").
A gap should remain between the separator and the bottom of the main
wash chamber, if the separator has been correctly installed (fig. "B" and
"C").
For use with liquid detergent: place the separator in the lower position.
Secure the separator in the chamber using the front guide rails.
Position the separator so that it touches the bottom of the main
wash chamber
(fig. "D").
10
Black process 45.0° 100.0 LPI
Separator
A
( )
}
Hooks
Separator
Guide
Rails
B
2
3
1
C
D
A
Advertisement
Table of Contents
