Parkside 353556 2010 Operation And Safety Notes page 27

measurement mode to turn on the laser
beam. Once the laser beam is turned on,
hold the MEAS button
and slowly move the product over the
surface to be measured, the product will
continuously measure the distances.
Measured values will be shown on the
display .
2
Note:
- Under continuous measurement mode,
the movement should be slow. Fast move-
ment of this product may get you
wrongly measured values (or) unreliable
values. Under such circumstances, you
could wait for more than 1 second with-
out any movement. You will get correct
value on the display
move slowly further for next measurement.
- Under continuous measurement mode,
the laser beam will be keep flashing as
long as the MEAS button
- Press MODE button
ured values.
pressed down
6
. Then, you can
2
is pressed.
6
to clear meas-
10
GB 27