Installation - Sony MEX-GS820BT Operating Instructions Manual

Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1
(not supplied) is required before use.
1
To enable the steering wheel remote
control, select [SET STEERING]  [EDIT
CUSTOM] to make the registration (page 22).
When the registration completes, the steering
wheel remote control becomes available.
Notes on installing the connection cable
RC-SR1 (not supplied)
• Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper
connection may damage the unit.
• Depending on the type of car, be sure to insulate
the unused leads with electrical tape for safety.
• Do not connect this cable when the steering wheel
remote control is not used.
• Consulting the dealer or an experienced
technician for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [STR
CONTROL] in [SET STEERING] to [PRESET]
(page 22).

Installation

Removing the protection collar
and the bracket
Before installing the unit, remove the
protection collar  and the bracket  from
the unit.
1
Pinch both edges of the protection
collar , then pull it out.

2
Insert both release keys  until they
click, and pull down the bracket ,
then pull up the unit to separate.


Face the hook inwards.
43
GB