Cleaning Antenna Housing; Tv And Sound System; Tv Wall Plate Power Supply; Operation - Airstream Bambi 2020 Owner's Manual

Cleaning Antenna Housing

The antenna is constructed with an automotive-grade
plastic� Clean only with mild soap and water� Use no
solvents, alcohol, or cleaning fluids. Do not power wash
any part of the base mount of head of the antenna�

TV and Sound System

Bambi trailers are equipped with a TV/DVD
combination unit and a JVC AM/FM/CD unit with
built-in Bluetooth� Please refer to the documentation
included in your owner's packet for instructions on their
use�

TV Wall Plate Power Supply

The wall plate/power supply provides 12 VDC to the
antenna as well as antenna signals to two TV sets�
Cable input from outdoor receptacle connects to the
wall plate and may be switched so either antenna or
cable/satellite signals may be watched�

Operation

To receive cable signals from the outdoor receptacle:
Press switch to OFF position� The light on the wall
plate will go (OFF) showing that power is no longer
connected to the antenna and that both TV sets are
receiving signals from the outdoor receptacle� To
receive signals from antenna: Press switch to ON
position� The light on the wall plate will come (ON)
showing that power is connected to the antenna and
both TV sets are receiving signals from the antenna�
Review the manuals included in your owner's packet
before operating the system�
2020 Bambi

Solar System

Airstream utilizes Zamp solar panels and a Sun-
Explorer charge control and display� Cut the cord to
expensive daily shore power hook-ups with the 12-volt
solar charging system� Ensuring the panels are clean,
not partially shaded by trees or other interference will
promote solar charging�
The Sunexplorer charge control performs these basic
functions:
1� It senses when the battery is fully charged and
disconnects the charge current to avoid over-
charging the battery�
2� It resumes charging the battery when the battery
voltage has dropped sufficiently to accept
additional charge current�
3� It checks the availability of charge current, by
cycling the relay every 4 minutes� If there is
insufficient charge current available, it's internal
relay will disconnect the battery to prevent
discharge through the solar panels at night�
Three different colored LED's indicate the status of the
battery charge� Green = Full, Yellow = Partial, blinking
Orange = low� When orange LED is blinking, due to low
voltage, both the green and yellow LEDs will be dimly
lit� Manuals on their use are included with the Airstream
owner's packet�
For those units manufactured without the solar panel
option, a 3-port plug-in has been pre-wired on the
roof� This port allows for roof mounted solar panels to
be installed after manufacturing without the need for
running wires� A single port has also been pre-wired
in the front of the unit near the battery box� This port
is a quick plug-in for a portable solar charging kit�
These ports are designed for solar panels added after
manufacturing�
Refer to Section 8 - Maintenance for Solar Panel
Wiring diagram and information�
Interior
5-11