Table of Contents
Advertisement
Note: When you are operating the pinwheel form feeder under low
humidity
conditions
and feeding printed forms
into
metal paper
bins,
you should ground the paper bins to the printer. Place the grounding
wire from
the
paper bin on top of the printer cable grounding wire
located
at the rear of the
printer.
See
"
Attaching the Printer
Cable"
on page 2-12.
Removing
Continuous Forms
3-22
1.
Press
Start/Stop
to
turn off
the
Ready
light.
2.
Carefully tear off
the
unfed forms along
the
perforations as
close
to the printer as
possible.
Hold the blank form with one hand and
tear with
the other.
3.
Press tor
Form Feed
to feed
the
forms out of the
printer.
,--.
,-.,_
Advertisement
Table of Contents
