Table of Contents
Advertisement
,.......
Transparencies
The IBM "Quietwriter" Ill Printer may be used to print directly on
transparencies. Print quality and durability depend on the transpar-
ency used. Therefore, transparencies should be tested for accepta-
bility.
Below are several considerations for printing on
transparencies:
•
Transparencies produced for use with infrared copiers generally
give acceptable results when printing is done on the front or non-
infrared
side.
In general the front of the transparency is identified
by placing the "notch
"
in the transparency in the upper right-hand
corner or as recommended by the individual
manufacturer.
•
A white sheet of xerographic paper must be loaded behind each
transparency.
•
Use the Quality print mode.
•
Information printed on the transparency is not
indelible;
it can be
removed.
Listed below are three transparencies which have been tested with
the
printer.
Since changes in the design or manufacture of these
transparencies by the manufacturer cannot be anticipated by IBM
,
these transparencies should be tested for acceptable results with
your application.
•
3M, Scotch
6
7100, Transparency Film for Infrared
Copiers,
D.C./Part
No.
021200-16819
•
3M
,
1301
,
Transparency Film for Overhead
Projection,
Infrared
Transparency
Film,
Reorder Number 78-6969-5495-3
•
Labelon
Corporation, TR-45,
Projection
Transparencies-Infrared,
Order
No.
TR-45C.
Other transparencies may provide acceptable results for your appli-
cation. However,
they should also be tested.
s
Trademark of 3M
Supplies
5-13
Advertisement
Table of Contents
