Table of Contents
Advertisement
1. Press and slide the back cover to open the battery
compartment of the remote control.
2. Insert two AAA size batteries. Make sure to match the
(+) and (-) ends of the batteries with the (+) and (-) ends
indicated in the battery compartment.
3. Restore the battery compartment.
Press the button and slide
Insert the batteries
IMPORTANT INFORMATION ABOUT THE REMOTE AND
BATTERIES
• Discard batteries in a designated disposal area. Do not
throw them into a fire.
• Remove old batteries immediately to prevent them from
leaking into the battery compartment.
• If you do not intend to use the remote control for a long time,
then remove the batteries.
• Battery chemicals can cause a rash. If the batteries leak,
clean the battery compartment with a cloth. If chemicals
touch your skin then wash it immediately.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
(NiCd, NiMH, etc.) batteries.
• Do not continue using the remote if it gets warm or hot.
• Call our Support Center immediately on the support website.
REMOTE CONTROL RANGE INFORMATION
• The remote control can work at a distance of up to 26 feet in
• It can work at a 30 degree horizontal or vertical angle. ( This
PAIRING THE REMOTE CONTROL
1.Pair the remote to the TV after you power it on. Keep the remote
Restore the compartment
2.If the remote paired successfully then a confirmation will
NOTE:
• If an unknown error occurred with the remote then it could
• If an unknown error occurred in the remote control while the
• The remote cannot be paired to the TV while the TV is in
14
front of the TV set. (This distance is used by infrared means
in an unpaired state.)
angle is used by infrared means in an unpaired state.)
control within 20 feet from the TV. Press and hold the [
at least 3 seconds to start pairing.
display on the screen. If it did not pair successfully then an
'unsuccessful' message will display. Repeat step 1.
have been caused by interference. Try to remove what's
causing the interference and pair it again.
battery power is normal, you can take out the batteries and
press any key for 1~2 seconds, then the remote control can
work normally.
standby mode.
] button
Advertisement
Table of Contents
