Dell E75S001 Reference Manual page 10

Table 5. Processor Settings details (continued)
Option
Processor Core Speed
Processor Bus Speed
Local Machine Check Exception
Processor n
Table 6. Processor details
Option
Family-Model-Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores
Maximum Memory Capacity
Microcode
SATA Settings
To view the SATA Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >
SATA Settings..
Table 7. SATA Settings details
Option
Embedded SATA
Security Freeze Lock
10 Pre-operating system management applications
Description
Specifies the maximum core frequency of the processor.
Specifies the bus speed of the processor.
Enables or disables the local machine check exception. This
is an extension of the MCA Recovery mechanism providing
the capability to deliver Uncorrected Recoverable (UCR)
Software Recoverable Action Required (SRAR) errors to
one or more specific logical processors threads receiving
previously poisoned or corrupted data. When enabled, the
UCR SRAR Machine Check Exception is delivered only to the
affected thread rather than broadcast to all threads in the
system. The feature supports operating system recovery for
cases of multiple recoverable faults that are detected close,
which would otherwise result in a fatal machine check event.
The feature is available only on Advanced RAS processors.
This option is set to Disabled by default.
The following settings are displayed for each processor:
Description
Specifies the family, model, and stepping of the processor as
defined by Intel.
Specifies the brand name.
Specifies the total L2 cache.
Specifies the total L3 cache.
Specifies the number of cores per processor.
Specifies the maximum memory capacity per processor.
Specifies the processor microcode version.
Description
Enables the embedded SATA option to be set to Off, AHCI mode , or RAID modes.
This option is set to AHCI Mode by default.
NOTE:
1. You might also need to change the Boot Mode setting to UEFI. Otherwise, you
should set the field to Non-RAID mode.
2. No ESXi and Ubuntu OS support under RAID mode.
Sends Security Freeze Lock command to the embedded SATA drives during POST.
This option is applicable only for AHCI Mode. This option is set to Enabled by default.
NOTE: The processor bus speed option displays only
when both processors are installed.
NOTE: Depending on the number of processors, there
might be up to n processors listed.