Geely GEOMETRY C Manual page 48

Problems, possible causes and solutions
Question
The power does not
open.
System fault
Poor picture color/
tone quality.
There is no sound.
Poor sound or image
quality.
USB does not work.
Possible cause
Fuse blown.
Improper device
connection.
Low battery
The brightness,
saturation and contrast
settings are not
reasonable.
Set the volume low or
mute state.
Poor connection.
No sound is made
when the device is fast
forwarding, fast
rewinding, scanning, or
playing at low speed.
Vibration occurs at the
changeover switch.
Poor image color/tone
quality.
The USB disk is
damaged.
The USB drive is
contaminated.
The USB hub used
was purchased
separately.
45
Multimedia system
Solution
Replace the fuse with a suitable one.
If the fuse blows again, you should
contact Geely service station.
Verify that the device is properly
connected.
Charging the battery.
Set the brightness reasonably in the
display settings.
If the problem still exists, please
contact Geely service station.
Set the volume or unmute reasonably
in the sound settings.
Check to see if the device is
connected.
Cancel fast forward, fast rewind, scan
or low speed playback.
Because of the vibration, the sound
may be short-circuited and the image
distorted, and the device will return to
normal once the vibration stops.
Use images with high color/tone
quality.
Format the USB drive to FAT16/32,
exFAT, NTFS and then use it.
Remove impurities between the
contact surface of the USB disk and
the multimedia terminal.
Plug the USB drive directly into the
car's multimedia terminal.
1