Troubleshooting; Common Faults And Maintenance - Geely GEOMETRY C Manual

Multimedia system

Troubleshooting

Common faults and maintenance

Possible cause
1.
Failure during operation or installation may be mistaken for physical equipment failure.
2.
If the device fails, try the following suggestions.
3.
If the problem cannot be solved, please contact Geely service station.
Problems
There are red or
green dots on the
screen.
No sound or no
image.
There is a navigation
screen but no sound.
When the power is
turned on, the
corners of the
multimedia display
are dark.
Only one speaker has
sound.
The external device
does not work.
The last play mode
cannot be loaded
when the power is
turned on.
Because LCDs are manufactured using highly dot-dense
technology, 0.01% of the total number of pixels may have pixel
defects or insufficient illumination.
Is the vehicle switched to "ACC" or "ACC ON" mode?
Is the navigation system turned off?
Is the navigation system turned off? Is the volume setting too
low?
Is the mute set?
After long use time multimedia display slightly dark is normal, not
a fault.
If the multimedia display is very dim, please contact a Geely
service station for assistance.
Whether the volume control or sound balance control is set to one
side only.
Is the external unit connected with a standard connection cable?
Before turning off the power, if the content played is an external
file on a device such as USB, Bluetooth, etc., when the power is
turned on again, it may not be loaded and the display will be in
last playback mode.
If the corresponding device is not connected, play in the
operation mode with a higher priority than the recent playback
mode.
If the previous playback mode cannot be loaded for playback, it
will be played in the operation mode with higher priority.
44
Possible cause