Watchguard NX3CE12 Hardware Manual page 8

Hardware Specifications
Interface ports available with the optional fiber card
If you install the optional fiber card for the XTM 1050, it replaces the four copper interface ports
numbered 8–11. There is an activity link indicator for each fiber port, but the location of the activity
indicator is different from the location of the activity indicators for ports 0-7. See the diagram below
for the location of the fiber activity indicators for each port.
Interface ports available with the optional 10 Gb Interface Module
If you install the optional 10 Gb Interface Module for the XTM 1050, it replaces the four copper
interface ports numbered 8–11 with two interface ports numbered 8 and 9. There are activity and
connection speed indicators for each 10 Gb interface port, but the location indicators is different from
the location of the indicators for ports 0-7. See the diagram below for the location of the activity and
connection speed indicators for each port on the 10 Gb Interface Module.
For each interface port on the 10 Gb Interface Module:
o The Activity LED blinks when data is sent or received.
o The Connection LED is blue when the interface operates at 10 Gb.
Note
After you install the 10 Gb Interface Module, interfaces 10 and 11 are still visible in the device
configuration, but are unused, even if you configure them in the management software.
6
Activity Indicator Locations on the XTM 1050 Fiber Card
Activity LED 8
Activity LED 9
Indicators on the 10 Gb Interface Module
Activity LED 8
Connection LED 8
Activity LED 10
Activity LED 11
Activity LED 9
Connection LED 9
WatchGuard XTM 1050