Daikin CORA FTXM20QVMA Operation Manual page 23

NOTE
Notes on COUNT UP-DOWN ON/OFF TIMER
• After setting, the time displayed on the LCD will automatically count down by 1 hour for every 1 hour that passes.
For example, if the OFF TIMER is set to 3 hours, the display will change as follows: 3hr
Switching between ON/OFF TIMER display modes (24 hour clock and hours remaining display)
• When change display mode (from 24 HOUR ON/OFF TIMER to COUNT UP-DOWN ON/OFF TIMER or
from COUNT UP-DOWN ON/OFF TIMER to 24 HOUR ON/OFF TIMER), cancel timer. So, to use timer, set timer again.
To use the ON/OFF TIMER with an hours remaining
display (COUNT UP-DOWN ON/OFF TIMER)
• Check that the clock is correct.
If not, set the clock to the present time.
1.
Press and hold
5 seconds, when signal indicater ( ) blink,
release your fi nger from the button.
For ON TIMER
" " is displayed on the LCD.
" " blinks.
For OFF TIMER
" " is displayed on the LCD.
" " blinks.
• " " and day of the week disappear from the LCD.
2.
Press until the time setting reaches the point
you like.
• Each pressing of the button increases or decreases the time setting by 1 hour.
• The time can be set between 1 and 12 hours.
3.
Press or
• " " or " ", and setting time are displayed on the LCD.
• The TIMER lamp lights orange.
• To change the display mode from COUNT UP-DOWN ON/OFF TIMER to
24 HOUR ON/OFF TIMER, repeat STEP
" 24 HOUR ON/OFF TIMER ".
• Timer display mode cannot be changed while "
Press
Display
Combining display modes
• Different display modes (24 HOUR ON/OFF TIMER and COUNT UP-DOWN ON/OFF TIMER)
can be used for the ON TIMER and OFF TIMER simultaneously.
(Example)
Present time: 22:00 [unit is in operation]
OFF TIMER at 1:00 (3 hours after present time)
ON TIMER at 6:00 (8 hours after present time)
Page 10
or for about
again.
1
Page 20,21
or to stop the blinking.
Combined
→ → →
2hr 1hr blank (OFF)
TIMER Operation
2
, and continue from STEP of
" or " " are blinking.
22