Advertisement
6. Connect Network Cables
1
1
Install QSFP+ transceivers in the QSFP+ slots.
2
Connect fiber optic cabling to the transceiver ports. Or,
connect DAC cables directly to the QSFP+ slots.
The following transceivers are supported:
◆
40GBASE-CR4 (DAC)
◆
40GBASE-SR4
◆
40GBASE-LR4
Note:
As connections are made, check the port status LEDs
to be sure the links are valid. The QSFP+ ports have four
LEDs; one LED on amber indicates a valid 40G link, when
LEDs are on green it indicates 10G links on each lane.
7. View the Product Label
1
The switch product label is located below the Mgmt and
Console ports on the right side of the front panel. Pull the
label out to view the product information.
2
– 2 –
Hardware Specifications
Chassis
Size (WxDxH)
438.4 x 515 x 43.5 mm (17.26 x 20.28 x 1.71 inch)
Weight
9.65 kg (21.27 lb), with two installed PSUs
Temperature
Operating: 0° C to 40° C (32° F to 104° F)
Storage: -40° C to 70° C (-40° F to 158° F)
Humidity
Operating: 5% to 95% (non-condensing)
Operating
Up to 3000 m (10,000 ft)
Altitude
Acoustics
Noise Emission LpA=79 dB at virtual workspace
according to DIN 45635 T.19
Switch Power
355 Watts maximum
Consumption
AC PSU
PSU AC Input
100-240 VAC, 50-60 Hz, 6 A max.
Rating
PSU DC Output
52.9 A @ 12 VDC (typical load)
Rating
4 A @ 5 VDC (typical load)
Regulatory Compliances
Emissions
EN 55022:2010, Class A
EN 61000-3-2:2014, Class A
EN 61000-3-3:2013
FCC Class A
VCCI Class A
CE Mark
Immunity
EN 55024:2010
IEC 61000-4-2/3/4/5/6/8/11
Safety
EN60950-1:2006+A11:2009+A1:2010+A12:2011
/ IEC60950-1:2005; Am1:2009
Quick Start Guide
Advertisement
