Sealey RE229.V2 Instructions

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years
of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE
THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
 DANGER! Stop compressing the spring before the coil windings touch, fig.2.A. Exercise particular caution
when using an air impact wrench.
 WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are
adhered to when using this equipment.
 WARNING! Wear approved safety eye protection (standard spectacles are not adequate).
 WARNING! Do not compress the spring to an extent where the jaws touch, fig.2.B.
 DO NOT operate spring compressor if parts are damaged or missing as this may cause failure and/or
personal injury.
 DO NOT force the spring compressor to achieve a task it was not designed to perform.
 DO NOT allow untrained persons to use the spring compressor.
 Familiarise yourself with the applications, limitations and potential hazards of the spring compressor.
 Maintain the spring compressor in good condition. Replace or repair damaged parts.
Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
 Keep the work area clean, uncluttered and ensure there is adequate lighting.
 Keep hands and body clear of the spring when operating the spring compressor.
 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
 Remove ill fitting clothes. Remove ties, watches, rings, other loose jewellery. Contain and/or tie back long
hair.
 Wear appropriate protective clothing.
 When not in use, clean and store the spring compressor in a safe, dry, childproof location.
2. INTRODUCTION & DESCRIPTION
Capacity
Gold Yokes:
2. TECHNICAL SPECIFICATIONS
Black Yokes:
Silver Yokes:
2.1. Introduction
2.1.1. Suitable for Macpherson strut coil springs. Features a yoke
extension bracket that also allows use on conical springs.
Supplied with three pairs of different sized interchangeable
yokes, for a wide range of vehicle applications and plastic yoke
protectors that protect the spring coating from damage which
can invalidate the vehicle manufacturer's warranty. Safety
yokes are carefully shaped to stop the spring bowing while
under compression.
2.2. Description (Fig.1)
2.2.1. The compressor consists of a solid steel body mounted with
two forged jaw interlocks, one on the body and the other on a
centrally mounted spindle.
1 Retaining bolts
2 Yoke
3 Compressor body
4 Hex nut
2.2.2. The spindle, is driven by a 21mm hex nut (Fig.1.4).
2.2.3. Each jaw has safety lips to eliminate slip and is designed to fit
the pitch of the spring to ensure maximum surface contact
between the jaws and the spring, thus eliminating the risk of
the compressor slipping around the spring.
INSTRUCTIONS FOR:
COIL SPRING COMPRESSOR
MODEL No:
1000kg
Ø80-105mm
Ø105-140mm
Ø145-190mm
5 Spring
6 Safety lips
7 Outer rib
Original Language Version
RE229.V2
Maximum Jaw Opening:
Drive:
265mm
21mm Hex
1
2
1
2
3
4
5
6
B
6
1
7
RE229.V2 Issue: 1 - 11/05/12
A
Fig.1