Macnaught HG 20F-012KMM-01 Instruction Manual

INTRODUCTION
Thank you for purchasing a Macnaught oil dispensing
gun. The Macnaught metered oil dispensing gun has
been designed for use with engine and gearbox oils up
to SAE140.
Please read and retain this instruction manual to
assist you in the operation and maintenance of this
quality product.
GENERAL INFORMATION
This manual assists you in operating and maintaining your
new oil control gun. The information contained will help
you ensure many years of dependable performance and
trouble free operation.
If you require further assistance please contact your local
Macnaught distributor or authorised Macnaught service
centre.
IMPORTANT INFORMATION
READ THIS INFORMATION CAREFULLY
CAREFULLY BEFORE USE.
Your safety is important to us. Please read and follow
all safety instructions listed inside.
"Cautions" listed throughout this manual advise of
potential practices or procedures which may cause
damage to your equipment.
HG20F-012KMM_inst_ Issue 1 © 2023
HG 20F-012KMM-01
OIL CONTROL GUN
INSTRUCTION MANUAL
Ensure all operators have access to the instructions
about safe operating and maintenance procedures.
Do not exceed the maximum working pressure of 6900
kPa / 1000 psi / 69 bar.
CAUTION
Do not hit the oil control gun if it fails to operate. Refer
to "trouble shooting guide" or return the unit to your
nearest authorised service centre.
Never point the nozzle at yourself or anyone else.
Never exceed the pressure rating of any component
installed in the System.
* Macnaught recommends the use of PPE equipment
such as safety glasses, protective gloves, safety
shoes etc before handling or using this product.
* Continual use of this product can potentially cause
RSI injury (especially hand or arm injury)
* Do not modify or alter this product any way
* Only physically fit people should be authorised to
use this product
* Ensure that any fluid spillage is cleaned up
immediately to prevent slipping or injury.
1