3.3.3 Components and connections of the charger document. 3.3.4 Charging indicators (LED) In no event shall PACCAR be liable for direct, indirect, Product identification special, incidental or consequential damages of any nature 3.4.1 Identification plate...
The information in this document is property of PACCAR No part of this document may be battery management system reproduced, stored in a retrieval system, or transmitted in any form or by any means electronic...
2. Safety Abbreviation Description MCCB molded case circuit breaker neutral OCPP open charge point protocol 2.1 General safety warnings protective earth (safety ground, gnd) Warning: power line communication • Obey this manual. proximity pilot • Make sure this manual is always available. personal protective equipment •...
3. Description 3.3.2 Charger 3.1 Product The depot charger (EVSE) is a power supply system for electric vehicles (EV). The depot charger charges the batteries of electric vehicles during a long-term stop or overnight stop. The charging occurs via a combined charging system (CCS) plug. Refer to section System overview on page 7.
3.3.3 Components and connections of the charger The stop button is equipped with an LED ring that indicates the status of the charging process. Status Duration Description No LED 10 seconds The charger is in an unavailable state. Green LED flashes 60 seconds The charger is in the startup phase.
3.5 Technical data 3.5.2 Standards 3.5.1 Charger specifications The product was produced and tested according to: • IEC61851-23: Electric vehicle conductive charging station Table 1: Identification • IEC61851-24: Digital communication between EC charging station and an electric vehicle for control of DC charging Type/Model PacMobile 25X...
4. Operation 4.8 How to Hard reset the charger Procedure 1. If the CCS plug is connected to the vehicle, disconnect the CCS plug. 2. Disconnect the AC cable from the mains. 4.1 Connect the AC input 3. Wait until all the LED ring does not show any light. Refer to Charging indicators (LED) on page 9. Procedure 4.
5. Troubleshooting 5.1 Service-line structure The service-line is structured in such a way that simple faults can be fixed with the help of the 1st line support. Depending on the complexity of the issue, you will be further directed to the specific service department.
Need help?
Do you have a question about the DAF PacMobile 25X and is the answer not in the manual?
Questions and answers