Mitsubishi Electric Mr.SLIM MSY-GK24VA Operating Instructions Manual page 7

I-
SAVE OPERATION
1
Press during COOL, ECONO COOL mode to
select i-save mode.
2
Set the temperature, fan speed, and airfl ow direction.
• The same setting is selected from the next time by simply pressing
.
• One group of setting can be saved.
• Select the appropriate temperature, fan speed, and airflow direction
according to your room.
Press again to cancel i-save operation.
• i-save operation also is cancelled when the MODE or POWERFUL
button is pressed.
i-save operation
A simplified set back function enables to recall the preferred (preset) setting with
a single push of the button. Press the button again and you can go back
to the previous setting in an instance.
Example of use:
1. Low energy mode
Set the temperature 2°C to 3°C warmer in COOL mode.
This setting is suitable for unoccupied room, and while you are sleeping.
2. Saving frequently used settings
Save your preferred setting for COOL/ECONO COOL. This enables you to
select your preferred setting with a single push of the button.
E
CONO COOL OPERATION
Press during COOL mode
ECONO COOL operation.
The unit performs swing operation vertically in various cycles according to the
temperature of airflow.
Press again to cancel ECONO COOL operation.
• ECONO COOL operation is cancelled when the VANE, LONG, or
POWERFUL button is pressed.
What is "ECONO COOL"?
Swing airfl ow (change of airfl ow) makes you feel cooler than stationary airfl ow. So,
even though the set temperature is automatically set at 2°C higher, it is possible to
perform cooling operation with keeping comfort. As a result, energy can be saved.
T
IMER OPERATION (ON/OFF TIMER)
1
Press or during operation to set the timer.
(ON timer) : The unit turns ON at the set time.
(OFF timer) : The unit turns OFF at the set time.
* or blinks.
* Make sure that the current time and day are set correctly.
2
Press (Increase) and
time of timer.
Each press increases or decreases the set time by 10 minutes.
• Set the timer while or
3
Press or again to cancel timer.
Note:
• ON and OFF timers can be set together.
operations.
• If power failure occurs while ON/OFF timer is set, see
function".
page 4 to start
Page 3
(Decrease) to set the
is blinking.
mark indicates the order of timer
page 4 "Auto restart
En-6