Mitsubishi Electric Mr.SLIM MSY-GK24VA Operating Instructions Manual page 4

● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART
Indoor unit
Front panel
Air fi lter
(Nano platinum fi lter)
Air cleaning fi lter
(Electrostatic
anti-allergy
enzyme fi lter)
Air inlet
Air outlet
Fan guard
Horizontal vane
Display section
Operation indicator lamp
Emergency operation switch
Remote control receiving section
Outdoor unit
Outdoor units may be different in appearance.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
4.
Press RESET.
1.
Remove the front lid.
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the battery is running low. In
7 days after the indicator starts lights up, the remote controller stops working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with expired
shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
En-3
Fan
Heat exchanger
Vertical vane
Page 4
Air inlet (back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
2.
Insert the negative
pole of AAA alkaline
batteries fi rst.
3.
Install the front lid.
Remote controller
Operation
display section
Temperature
buttons
Page 4
Operation
select button
Page 4
ECONO COOL
button
Page 6
POWERFUL
button
Page 5
i-save button
Page 6
Remote controller holder
• Install the remote
controller holder in a
place where the signal
can be received by the
indoor unit.
• When the remote
controller is not used,
place it in this holder.
Setting current time
1.
Press CLOCK.
4.
Press CLOCK again.
• Press CLOCK gently using a thin instrument.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard from
the indoor unit when the
signal is received.
Battery replacement
indicator
Page 3
ON/OFF
(operate/stop) button
LONG button
Page 5
WIDE VANE control
button
Page 5
FAN speed control
button
Page 5
VANE control button
Page 5
TIME, TIMER set
buttons
Pages 3, 6
Increase time
Decrease time
WEEKLY TIMER
set buttons
Page 7
RESET button
Page 3
CLOCK button
Page 3
Lid
Slide the lid down to open
the remote controller. Slide
it down further to get to the
weekly timer buttons.
Only use the remote controller
provided with the unit.
Do not use other remote controllers.
If two or more indoor units are
installed in proximity to one another,
an indoor unit that is not intended
to be operated may respond to the
remote controller.
3.
Press the DAY button
to set the day.
2.
Press either the TIME button or
the TIMER buttons to set the
time.
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer).