Table of Contents
Advertisement
Section 4
Hardware Setup
Isolated Input Expansion Board
Figures 4-1 and 4-2 illustrates the external connections for DC or AC
voltage operation. No jumpers are required on this board.
Figure 4-3 illustrates the physical location of the terminals on the
expansion board.
Note: The diagnostic screens (Digital I/O) can be used to verify proper
operation of the inputs. Refer to the motor control manual.
Figure 4-1 Typical Connections EXB003A02 and A03
Figure 4-2 Typical Connections EXB003A04 and A05
Terminal tightening torque is 7 lb–in (0.8 Nm) maximum.
(Not compatible with 19H and 20H)
Setup 4-1
Advertisement
Table of Contents
