1. SAFETY PRECAUTIONS Be sure to read the instructions in this section carefully before use. Make sure to observe the instructions in this manual as the conventions of safety symbols and messages regarded as very important precautions are included. We also recommend you keep this instruction manual handy for future reference. Safety Symbol and Message Conventions Safety symbols and messages described below are used in this manual to prevent bodily injury and property damage which could result from mishandling.
Page 4
SAFETY PRECAUTIONS When the Unit is in Use When Installing the Unit Do not place heavy objects on the unit as this may Never plug in nor remove the power supply plug cause it to fall or break which may result in with wet hands, as doing so may cause electric personal injury and/or...
2. GENERAL DESCRIPTION This product is a six zones mixer amplifier, combining of high-performance switching power supply+H -class amplifier chip Built in Bluetooth and Tuner, with 2U chassis design, high efficiency, light weight, beautiful appearance. 3. FEATURES 1. 4 channel Mic inputs, 2 channel line inputs, separated treble and bass control. 2.
4. NOMENCLATURE AND FUNCTIONS 4.3 REAR PANEL LINE LINE2 LINE1 ZONE ZONE ZONE ZONE ZONE ZONE FM ANT MUTE REMOTE MIC COM 100V 100V 100V 100V 100V 100V XLR BAL MIC 4 MIC 3 MIC 2 MIC 1 1-GND 2-HOT+ BATT SUPPLY OUTPUT 3-COLD-...
5. OPERATION ILLUSTRATION 1. Connect the speakers: Total impedance Total impedance OUTPUT OUTPUT OUTPUT 100V 100V 100V COM 4-16Ω COM 4-16Ω COM 4-16Ω (FLP-MA-6120) FLP- MA-6120) FLP- MA-6240) FLP- MA-6240) 4~16Ω 70V LINE 100V LINE 1. Before connecting the speakers, please make sure that the equipment is powered off. In the case of power on, may have the risk of electric shock.
Page 9
5. OPERATION ILLUSTRATION Microphone using: 1.Turning the volume knob to the left,Connect the microphone and microphone input interface. 2.Turning the volume knob in the right position. 3.Facing the microphone and Speak loudly, turn the volume knob to the right, until the output signal no longer distortion.If input is high but output is low voice, and then increase the volume by using the volume knob.If the speaker volume is very high, then reduce the volume by using the volume knob.
Page 10
5. OPERATION ILLUSTRATION 7.Mobile phone bluetooth operation method: ①Press the MODE button on the MP3 player and set to bluetooth MODE. " " ②Enter the mobile phone Settings, find the bluetooth related Settings. ③Click on the bluetooth switch, turn on the bluetooth, if already turned on, then ignore. Because mobile phone system is different, setting interface may be a little different.
6. TROUBLESHOOTING Failure phenomena Failure cause 1 Power line is cut off 1. Power switch is not opened 2. The protection function of the equipment is not activated 1. The power switch is not opened or the power plug is bad contacted. 2.
9. SPECIFICATIONS Model FLP-MA-6120 FLP-MA-6240 Rated Power 120W 240W Speaker Output 4~16Ω/ 70V/100V MIC:5mV ±1mV LINE: 350mV±20mV Input Sensitivity AUX: 350mV±20mV EMC/TEL: 775mV Pre-output AUDIO OUT: 1V±50mV/ 100Ω :±10dB at 100Hz; Low frequency Mic Tones :±10dB at 10KHz High frequency :±10dB at 100Hz;...