Do you have a question about the LOGIC COMBI C30 and is the answer not in the manual?
Questions and answers
Darren Gillespie
April 17, 2025
I had to re pressure my boiler and must have turned the wrong valve for the hot water to my taps and shower. can you please tell me the colour and position of the valve under the boiler to open the hot water to taps once more. thank you for any help you can give me regarding this problem. My gas boiler is the combi 2 c30
1 comments:
Mr. Anderson
May 9, 2025
The valve is blue and should be turned to the horizontal position to open the hot water to taps.
Benchmark Commissioning Checklist. You can check your installer by calling Gas Safe Register direct on 0800 4085500. Ideal Boilers is a member of the Benchmark scheme and fully supports the aims of the programme. Benchmark has been introduced to improve the standards of installation and commissioning of central heating systems in the UK and to encourage the regular servicing of all central heating systems to ensure safety and efficiency.
BOILER OPERATION Legend A. Domestic Hot Water Temperature Knob B. Central Heating Temperature Knob BOILER C. Mode Knob ºC D. Boiler Status Display E. Burner ‘on’ Indicator HOT WATER PREHEAT Preheat On Off button G. Restart button MODE PREHEAT RESTART H.
3. SYSTEM WATER PRESSURE EFFICIENT HEATING SYSTEM OPERATION The boiler is a high efficiency, condensing appliance which will The system pressure gauge indicates the automatically adjust its output to match the demand for heat. central heating system pressure. If the pressure Therefore gas consumption is reduced as the heat demand is is seen to fall below the original installation reduced.
CONDENSATE DRAIN GENERAL INFORMATION This appliance is fitted with a siphonic condensate trap system BOILER PUMP that reduces the risk of the appliance condensate from freezing. The boiler pump will operate briefly as a self-check once every 24 However should the condensate pipe to this appliance freeze, hours, regardless of system demand.
POINTS FOR THE BOILER USER Note. In line with our current warranty policy we would ask that you check through the following guide to identify any problems external to the boiler prior to requesting a service engineer’s visit. Should the problem be found to be other than with the appliance we reserve the right to levy a charge for the visit, or for any pre-arranged visit where access is not gained by the engineer.
NORMAL OPERATION DISPLAY CODES DESCRIPTION DISPLAY CODE ON BOILER The boiler is in standby operation awaiting either a central heating call or hot water demand. The boiler has a call for central heating but the appliance has reached the desired temperature set on the boiler.
FAULT CODES DESCRIPTION ACTION DISPLAY CODE ON BOILER Low Water Pressure Check system water pressure is between 1 & 1.5bar on the system pressure gauge. To re-pressurise the system see Section 3. If the boiler still fails to operate then please contact Ideal (if under warranty) or alternatively a Gas Safe Registered Engineer if outside of the warranty period.
Need help?
Do you have a question about the LOGIC COMBI C30 and is the answer not in the manual?
Questions and answers
I had to re pressure my boiler and must have turned the wrong valve for the hot water to my taps and shower. can you please tell me the colour and position of the valve under the boiler to open the hot water to taps once more. thank you for any help you can give me regarding this problem. My gas boiler is the combi 2 c30
The valve is blue and should be turned to the horizontal position to open the hot water to taps.
This answer is automatically generated