Changing The Location Of The Lights; Using Attachments And Accessories - Toro 74480 Operator's Manual

Changing the Location of
the Lights
You can change the location of the lights on the roll
bar as shown in Figure
To change the mounting location, perform the
following:
1. Remove the screw (5/16 x 3/4 inch), locknut
(5/16 inch), and tube clamp securing each light.
2. Install the 2 tube clamps to the roll bar in the
desired location (Figure
3. Secure each light to the tube clamps using the
previously removed screw (5/16 x 3/4 inch) and
locknut (5/16 inch).
Note:
Do not install the light in a location where
it covers any roll bar decal.
Figure 14
1. Mounting locations for the lights
14.
14)
Using Attachments and
Accessories
Use only Toro approved attachments and accessories.
If you add more than 1 accessory-mount kit (i.e.,
bucket kit or universal mount kit) is added to any of
the 4 locations shown in
kit. Contact an Authorized Service Dealer for the
front-weight kit.
1. Add a front-weight kit when 2 or more accessory-mount kits
are installed at these positions.
g037646
21
Figure 15, add a front-weight
Figure 15
g037417