D-Link DAS-3626 User Manual page 7

Interface IP Settings for Switch Management
The switch maintains two IP interfaces used for management, one in-band IP interface named System, and one out-
of-band IP interface named outband. These IP interfaces cannot reside within the same subnet. If the outband
interface is configured with IP settings that place it within the same subnet as the System IP interface, the IP interface
for outband is invalidated.
The default IP settings of the in-band IP interface System are 10.90.90.90/255.0.0.0. The default IP settings for the
ou-of-band IP interface outband are 192.168.1.10/255.255.255.0. The CLI command syntax used to change the IP
settings of the in-band IP interface is config ipif System ipaddress xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy where the x's
represent the IP address to be assigned to the IP interface named System and the y's represent the corresponding
subnet mask. The CLI command syntax used to change the IP settings of the out-of-band IP interface is config ipif
outband ipaddress xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Alternatively you can use CIDR notation for the IP settings,
xxx.xxx.xxx.xxx/z, where the x's represents the corresponding number of subnets.
Connection to the switch using Telnet can be done by connecting to the Management Ethernet port and launching the
Windows Command Prompt or similar software. Make sure your computer's IP settings allow connection to the switch
default IP subnet of the outband interface (192.168.1.0) and Telnet to 192.168.1.10. You will be prompted for a User
Name and Password, there is no default user name or password, simply press the Enter at each prompt to obtain the
administrator's prompt DAS-3626:admin# as seen in the example below. The switch is not ready for configuration.
Figure 2. Menus Command Prompt using out-of-band Telnet connection
DAS-3626 VDSL2 Switch User Manual
NOTE: Telnet can also be used in-band by connecting through port 25 or
26. The Factory default IP address of the in-band interface "System" is
10.90.90.90.
7