Related Manuals for Benchmark 1282-111
Summary of Contents for Benchmark 1282-111
- Page 5 Oxygen nydrogen explosive Combustible...
- Page 6 CAUTION! Always ensure that the tool has stopped before disconnecting the air supply Do not wear watches, rings, bracelets, or loose clothing when using any air-powered tool Do not overload the tool. Allow the tool to operate at its optimum speed for maximum efficiency.
- Page 7 Recycle unwanted materials rather than disposing of them as waste. Sort the tools, hoses, and packaging in specific categories and take to the local recycling center or dispose of in an environmentally safe way. SYMBOLS Read operator s manual: To reduce the risk of injury, user must read and understand operator s manual before using this product.
- Page 8 Use compressed air at regulated pressure: Always use clean, dry, and compressed air at the regulated pressure. Do not exceed the maximum operating pressure of 50 PSI. Failure to comply could lead to serious injury or loss of life. ...
- Page 9 8 Air adjusting knob...
- Page 10 This spray gun has all-metal components and reinforced base for long lasting durability. Features include an adjustable pattern and material control for total control and an even coat.
- Page 12 Keep hands and other parts of the body away from the work areas when connecting the tool to the air supply. Failure to comply could lead to serious injury or loss of life. It is recommended that a filter-regulator-lubricator be used and be located as close to the tool as possible.
- Page 13 Filling the paint canister 1 . Pour paint through a strainer,cheese cloth or a paint strainer to remove any foreign substance from the paint. 2 . Fill canister ( 1 ) three quarters full with paint (2) . 3 . Close the canister ( 1 ) by turning the lid (2) clockwise.
-
Page 14: Air Volume Adjustment
6. Plug in the compressor, turn on and set the pressure regulator to 40PSI. Attach one end of the air hose to the compressor and the other end of the air hose (1) to the tool (2). 7. Mixing and thinning of the paint should be performed in accordance with the paint manufacturer’s instructions. - Page 15 Operation Plug in the compressor, turn it on, set the pressure regulator to 40 PSI, attach one end of the air hose to the compressor and the other end of the air hose to the air tool. Hold the gun (1) in such a way that the nozzle is approximately 6-12”...
- Page 16 Do’s DONT’S Always move the gun in parallel direction. Do not press the trigger with the gun at an inclined or angled position. 1 . Improper / thin coating region 1 . Uniform coating region 2 . Uniform / thick coating region 2 .
- Page 17 CARING FOR YOUR SPRAY GUN The spray gun should be cleaned after every use. Any paint remaining inside the gun will thicken and may damage the inner components and the mechanism of the gun. Washing Procedure 1. Cover the air cap with a cloth and pull the trigger.
-
Page 18: Maintenance Required
Maintenance NOTE: Do not store the tool anywhere temperatures will fall below freezing. DANGER Disconnect the tool from the air compressor before maintenance, adjusting, cleaning, filling and when it is not in use. Ensure the needle is removed before disassembling the nozzle, to avoid damage to the nozzle closure housing. Repairs must be performed by a qualified service technician only. - Page 19 If any of the following symptoms appear while the tool is in use, turn it off and disconnect it from the air supply immediately. Failure to comply will lead to serious injury or loss of life. Disconnect the tool from the air supply before making any adjustments. Repairs must be performed by a qualified service technician only.
Need help?
Do you have a question about the 1282-111 and is the answer not in the manual?
Questions and answers