Related Manuals for Benchmark 1282-113
Summary of Contents for Benchmark 1282-113
- Page 5 SYMBOL MEANING Oxygen nydrogen explosive Combustible...
- Page 7 Recycle unwanted materials rather than disposing of them as waste. Sort the tools, hoses, and packaging in specific categories and take to the local recycling center or dispose of in an environmentally safe way. SYMBOLS Read operator s manual: To reduce the risk of injury, user must read and understand operator’s manual before using this product.
- Page 8 Use safety respirator: Toxic vapors produced by spraying certain materials can cause serious damage to health. Always wear safety gloves and a respirator to prevent hazards caused by inhaling toxic vapor or contact of solvent and paint with eyes or skin. Failure to comply may result in moderate injury.
- Page 12 Keep hands and other parts of the body away from the work areas when connecting the tool to the air supply. Failure to comply could lead to serious injury or loss of life. It is recommended that a filter-regulator-lubricator be used and be located as close to the tool as possible.
- Page 13 1 . Attach the empty canister ( 1 ) to the spray gun by lining up the threads then holding the gun stationary and twisting the canister clockwise until snug. Note : Do not tighten the canister too much by hand , as doing so may break the plastic canister.
- Page 14 7. Use a piece of cardboard or other scrap material as a target for trial spraying and adjust for desired spray pattern. 8. Test the consistency of the paint by making a few strokes on a cardboard target. If the stroke appears to be very thick, add a small amount of thinner.
- Page 15 1 . Plug in compressor , turn it on , set the pressure regulator to 40 PSI , attach one end of the air hose to the compressor and the other end of the air hose ( 1 ) to the air tool.
- Page 16 Do’s DONT’S Always move the gun in parallel direction. Do not press the trigger with the gun at an inclined or angled position. Do not stop the sprayer movement in between strokes, as this will cause a build-up of paint and result in runs.
- Page 18 Lubrication: If the tool and the compressor are not equipped with an in- line lubrication system, place fill 2to3 drops of pneumatic tool oil into the air inlet before each use or after every two hours of continuous use, depending on the characteristics of the workpiec...
- Page 19 If any of the following symptoms appear while the tool is in use, turn it off and disconnect it from the air supply immediately. Failure to comply will lead to serious injury or loss of life. Disconnect the tool from the air supply before making any adjustments. Repairs must be performed by a qualified service technician only.
Need help?
Do you have a question about the 1282-113 and is the answer not in the manual?
Questions and answers