Installation Using The Screw Holes On The Side Of This Product; Installing The Microphone - Pioneer DMH-220EX Installation Manual

5 cm
Leave ample
space
5 cm
Installation using the
screw holes on the side
of this product
1
Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw
holes are aligned with the screw holes
of the bracket, and tighten the screws at
three locations on each side.
Use either the truss head screws (5 mm
× 9 mm) or flush surface screws (5 mm ×
9 mm), depending on the shape of the
bracket's screw holes.
Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
Dashboard or console
Truss head screw or flush surface
screw
Be sure to use the screws supplied
with this product.
Installing the
microphone
• Install the microphone in a place where
its direction and distance from the driver
make it easiest to pick up the driver's
voice.
• Be sure to turn off (ACC OFF) the product
before connecting the microphone.
• Depending on the vehicle model, the
microphone cable length may be too
short when you mount the microphone
on the sun visor. In such cases, install the
microphone on the steering column.
The microphone is mounted on the sun
visor.
The microphone is mounted on the
steering column.
Use separately sold clamps to secure the
lead where necessary inside the vehicle.
For installation, contact your dealer or an
authorized Pioneer Service Station for
assistance.
7
En