Installation Using The Screw Holes On The Side Of This Product - Pioneer DMH-WT3800NEX Quick Start Manual

X:\print\KB045\KB045_UC_QSG(A5_Horizon).EN\020Chapter_EN.fm
vehicle's location display, and might
otherwise cause reduced display
performance.
• When installing, to ensure proper heat
dispersal when using this unit, make sure
you leave ample space behind the rear
panel and wrap any loose cables so they
are not blocking the vents.
5 cm
Leave ample
space
5 cm
• Do not forcibly insert this unit into the
dashboard/console when installing.
Applying excessive force to the USB
connector may cause a malfunction.
Installation using the
screw holes on the side
of this product
Read the following chapters to choose
from two types of installation methods
(floating style or modular style).
• Floating style installation (page 16)
• Modular style installation (page 17)
▶Floating style installation
Installation tips
The following procedure describes how to
install this product with an LCD screen
attached to the unit. Depending on the
16
En
vehicle or installation location, you may
need to adjust the mounting position of
the LCD screen in order to prevent
impairment of vehicle driving operations.
For details on the mounting LCD screen
dimensions, refer to The adjusting position
and mounting dimension of the display for
floating style installation (page 19) before
installing.
WARNING
Do not use a mounting sleeve to install this
unit to prevent it from popping out or
rattling.
1
Fasten this product to the factory
radio-mounting bracket.
Position this product so that its screw
holes are aligned with the screw holes
of the bracket, and tighten the screws at
three locations on each side.
TIP
The amount of this unit's protrusion from
the dashboard/console can be adjusted by
shifting the position of the screw hole of
this unit to the factory radio-mounting
bracket.
Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
3
Dashboard or console Detach the monitor cover from the
Binding head screw (5 mm × 8 mm) / LCD screen ( ), then connect the
Flush surface screw (5 mm × 8 mm) monitor cables to the LCD screen ( ).
Be sure to use the screws supplied After that, attach the LCD screen with
with this product. adjusting the up-down position ( ) to
2 this unit by using the screws each side
Fasten the LCD screen mounting
( ).
bracket to the main unit at the suitable
Push the monitor cables as far as
position.
possible in this product before
Depending on the vehicle, the front-
attaching the LCD screen.
back position of the LCD screen may
need to be adjusted to mount it. Use the
supplied spacer ( ) if you choose the
Insert the connector with the connector
front position to install the LCD screen.
projection ( ) side facing up. If you force
to insert the connector in upside down, it
may be broken.
LCD screen mounting bracket
Binding head screw (4 mm × 30 mm)
Spacer
TIP
The mounting left-center-right position of
the LCD screen mounting bracket can be
changed depending on the vehicle or
installation location of the main unit.
4
Secure the monitor cables to the hook
on the back of the LCD screen then
attach the monitor cover ( ) by using
the screws ( ).
DMH-WT3800NEX/DMH-WT38NEX
CAUTION
Monitor cover
Binding head screw (4 mm × 12 mm)
KB045_UC_QSG(A5_Horizon)