Assembling The Light Kit - Hunter 50717 Installation Manual

Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Insert the third screw, found in the
bag, in place and firmly tighten all the three screws.
Note:
Fan style may vary.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Note:
Fan style may vary.
Ceiling Bracket Hanging Fan

Assembling the LIght Kit

2 of 3
Light Kit Screw
bag
1 of 3
Light Kit Screw
bag
hardware
Installing the Bulbs and Glass
Tab
Notch
Lift the globe and align the notches in
the globe with the tabs in the light kit.
Wiring Canopy
Feed the wires coming from
the bottom of the motor
housing through the center
hole in the light kit assembly.
Connect the wires from the
light kit to the wires from the
fan. Connect the white wire to
the white wire. Connect the
blue wire to the black wire.
Tuck the excess wiring above
the light kit.
Carefully push all switch housing components
into the switch housing, then install the switch
housing plate using two short light kit assembly
screws, found in the hardware bag.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
Blades Light
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Wrap the keyhole slots around the
screws and twist counterclockwise.
2 of 2
Short Light Kit
Screw
bag
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Glass/Bulbs Wall Control
1886
ON
8