AEG RXB659E6NU User Manual page 20

20 www.aeg.com
Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
9.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The Super Freezing function
is switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The door has been opened
often.
The Super Freezing function
is switched on.
There is no cold air circula‐
tion in the appliance.
9.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to the "Installation" chapter.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
Attach the melting water out‐
let to the evaporative tray.
Switch off the Super Freez‐
ing function manually, or
wait until the function deacti‐
vates automatically to set
the temperature. Refer to the
"Super Freezing function"
section.
Set a higher/lower tempera‐
ture.
Refer to the "Closing the
door" section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Refer to the "Super Freezing
function" section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to the "Hints and
tips" chapter.