MSI X299 TOMAHAWK ARCTIC Quick Start Manual page 119

2. Reconnect the hard drive.
3. Reboot to Windows
Failed Hard Drive Member
1. Power off.
2. Replace the failed hard drive with a new one that is of equal or greater capacity.
3. Reboot the system to IRST Option ROM by press Ctrl + I keys during the POST.
4. Select the port of the destination disk for rebuilding, and then press Enter.
1.
2.
"Degraded" volume and disk available for rebuilding detected. Selecting
a disk initiates a rebuild. Rebuild completes in the operating system.
RAID Volumes :
None defined.
Physical Devices :
Port Device Model
1 XXXX-XXXXXXXX
2 XXXX-XXXXXXXX
[ ↑↓] - Select
5. Exit IRST Option ROM, reboot to Windows
6. When prompted to rebuild the RAID volume, click Yes.
7. The Intel Rapid Storage Technology application will be launched. Right-click
®
the new hard drive and select Rebuild to this Disk. The Rebuild Wizard will be
launched which will guide you through the process of rebuilding to the new hard
drive.
; the rebuild will occur automatically.
®
MAIN MENU
[
Create RAID Volume
[
DEGRADED VOLUME DETECTED
Delete RAID Volume
5.
DISK / VOLUME INFORMATION
[
Select the port of the destination disk for rebuilding (ESC to exit):
Port Drive Model Serial #
1 XXXX-XXXXXXXX
Serial #
XXXXXXXXXXXXXX
[ ↑↓] - Previous/ Next [ENTER] - Select
XXXXXXXXXXXXXX
[ESC] - Exit
]
4. Recovery Volume Options
]
4. Recovery Volume Options
Exit
]
Size
XXXXXXXXXXXXXX XXX.XGB
Size Type/Status (Vol ID)
XXX.XGB Non-RAID Disk
[ESC] - Exit
XXX.XGB Non-RAID Disk
[ENTER] - Select Menu
.
®
119
RAID Configuration