Cpu_Fan1, Pump_Fan1, Sys_Fan1~4: Fan Connectors; Jtbt1: Thunderbolt Add-On Card Connector - MSI X299 TOMAHAWK ARCTIC Quick Start Manual

CPU_FAN1, PUMP_FAN1, SYS_FAN1~4: Fan Connectors

Fan connectors can be classified as PWM (Pulse Width Modulation) Mode or DC Mode.
PWM Mode fan connectors provide constant 12V output and adjust fan speed with
speed control signal. DC Mode fan connectors control fan speed by changing voltage.
When you plug a 3-pin (Non-PWM) fan to a fan connector in PWM mode, the fan speed
will always maintain at 100%, which might create a lot of noise. You can follow the
instruction below to adjust the fan connector to PWM or DC Mode.
Important
You can switch between PWM mode and DC mode and adjust fan speed in BIOS
> HARDWARE MONITOR. And please make sure fans are working properly after
switching the PWM/ DC mode.
Pin definition of fan connectors
PWM Mode pin definition
1 Ground 2
3 Sense 4

JTBT1: Thunderbolt Add-on Card Connector

This connector allows you to connect the add-on Thunderbolt I/O card.
Auto-detection Mode fan connectors
+12V
Speed Control Signal
1 FORCE_PWR
3 SLP_S3#
5
1
CPU_FAN1/ PUMP _FAN1
1
SYS_FAN1~4
DC Mode pin definition
1 Ground 2
3 Sense 4
1
2
4
Ground
Voltage Control
NC
SCI_EVENT
SLP_S5#
Overview of Components
43