Samsung RS6GA Series User Manual page 35

To connect the water filtering hose to the water line
a
A
a
B
A. Water Line from unit
B. Water Line from Kit
Untitled-1 35
1. Loosen and remove the compression
nut (a) from the water line of the
refrigerator, and insert it to the water
filtering hose.
a
2. Tighten up the compression nut (a) to
connect the water filtering hose and the
water line.
3. Open the main water valve and check
for any leaks.
03
4. If there are no leaks, dispense about 10
litres of water or dispense the water for
6 - 7 minutes before actually using the
refrigerator to remove impurities inside
the water filtering system.
5. Secure the water line to a sink or a wall
using a clip.
CAUTION
• Do not tighten the water line
excessively. Make sure the water line is
not bent, pinched, or squashed.
• Do not mount the water line on any
part of the refrigerator. This may
damage the refrigerator.
NOTE
If you have to relocate the refrigerator
after connecting the water line, make sure
the joined section of the water line must is
straight.
English 35
2021-01-20 10:49:54