Comb Attachments - Braun BT 5070 Manual

Charge Indicator (5)
BT 5090/5070
• The charge indicator shows the status of the batteries.
• The charge indicator blinks green when the appliance is being charged.
When the battery is fully charged, the charge indicator shines permanently
green provided the appliance is connected to an electrical outlet.
• During cordless use the charge indicator blinks green.
• The charge indicator flashes red when the battery is running low.
You should be able to finish your current trimming sequence.
BT 5050/5030/5010
• The charge indicator (5) shows that the appliance is being charged. When
the battery is fully charged, the charge indicator turns off.

Comb attachments

• The combs can be taken off by pressing the release buttons (1c) with your
thumb and forefinger.
Beard trimming
• Place the precision comb (1a) on the appliance with the appliance turned
off (a).
• Make sure that the lock switch (6a) is in the upper position. Turn the length
selector (6b) to your desired length. The beard comb slides automatically up
or down (possible lenght settings 1 - 10 mm in 0,5 mm steps).
• To lock the comb at your desired length slide the lock switch (6a) down.
The length selector is fixed.
• It is advisable to begin with the highest setting and then reduce the setting
until you reach the desired beard length.
• Press the on/off switch (7). Hold the beard comb with the angled edge against
your beard and guide the trimmer against the direction of the hair growth (a).
• To avoid clogging the beard comb with hair, clean it from time to time with
a brush.
Contour Trimming / Styling
• The wide trimmer (2) evenly cuts and trims large areas. It is ideal for
shaping sideburns, moustaches and partial short beards. Take off the
comb. While stretching the skin, guide the wide trimmer against the
direction of hair growth (b).
(1a, 1b)
9