Programming Table - Samlexpower BGW-200 Owner's Manual

Battery guard waterproof

Hide thumbs

Table of Contents

Available languages

The LED will indicate a fault. The BGW will turn on

again after 1 minute.

Remote off

A switch can be installed between the OFF input and

the minus (–) to manually disable the BGW output.

The BGW will shut down immediately when the

connection is made. The BGW will turn on when

the connection has been disconnected.

LED

The LED has two functions. One is to indicate the

BGW's status. The different stages are explaned in

the LED STATUS below. The other is to configure/

programme the BGW. This operation is described in

the section "CONFIGURE/Programming".

LED STATUS

Led is on.

Two short blinks (then off

for a longer period).

One blink (1 second on

and 1 second off).

Three short blinks (then off

for a longer period).

LED is off.

CONFIGURE/PROGRAMMING

To enter the configure/programming mode, a

connection has be made between the CONFIG

input and the Minus (–). The LED will blink one

time when the connection has been made for

approx. 2 seconds. Once this is done, the

connection has to be disconnected.

The same connection can be made briefly (short) again

to set the correct position from the programming

table. The LED will light up as feedback.

At that point, program position #1 is selected.

STAGE EXPLAINED

BGW has enabled

(switched on) the output.

BGW is disabled because

the remote off has been

activated.

Undervoltage or

overvoltage detected.

BGW has been shut down

for one minute due to one

of the following causes:

Ground loss, temperature

protection, current

protection, low output

voltage.

BGW has been shut down

due to undervoltage.

The user can briefly (short) make the connection

again to select programme position #2, etc., etc..

If no connection is made for approx. 4 seconds,

the LED will display the set state again.

(Example: programme position #4 is set by a user,

the LED will blink 4 times)

Two types of settings are available. Positions 1

through 10 set the undervoltage threshold and reset

values. Positions 11 and 12 set the overvoltage

threshold and reset values. These settings must be

selected individually.

The programmed positions are also retained when

the battery voltage is disconnected.