Dukane 8950P User Manual page 51

3.8.2 Communication setup
1 ) Set up the communication condition of the CONTROL IN
to be connected to the computer by RS-232C communication, according to
the specifi cations of the computer's RS-232C port.
Using the SERIAL IN SETTING menu, select the proper baud rate and parity.
( Operating Guide - OPTION menu - SERVICE – COMMUNICATION –
SERIAL IN SETTING/SERIAL OUT SETTING)
2 ) Set up the same condition of the CONTROL IN
port connected each other with the same RS-232C cable.
Use the SERIAL IN SETTING menu for the CONTROL IN
SERIAL OUT SETTING menu for the CONTROL OUT
baud rate and parity. (
COMMUNICATION – SERIAL IN SETTING/SERIAL OUT SETTING)
Communication condition
3 ) Using the COMMUNICATION TYPE menu, select the DAISY CHAIN
for each projector. (
COMMUNICATION – COMMUNICATION TYPE)
NOTE
• The baud rate and parity of the CONTROL IN
set up when connecting the projector to the computer by Ethernet.
• An unsuitable setup may cause the malfunction of communication with an
external devise.
3.8.3 Communication port
When connecting the projector to the computer by Ethernet, send the data from
the computer to the projector with using the TCP # 9718 port.
Operating Guide - OPTION menu - SERVICE –
Item
BAUD RATE 4800bps/9600bps/19200bps/38400bps
PARITY NONE/ODD/EVEN
Data length 8 bit (fi xed)
Start bit 1 bit (fi xed)
Stop bit 1 bit (fi xed)
Operating Guide - OPTION menu - SERVICE –
3. Management with Web browser software
CONTROL IN port of the projector
CONTROL IN port and the CONTROL OUT
CONTROL IN ports, and the
CONTROL OUT ports, to set up the
Condition
CONTROL IN port do not need to be
CONTROL OUT
51