Jaxpety Sandinrayli TY91G0276 User Manual page 14

ERROR CODES
Fault Fault
Cod Description
e
E1 Communicatio
n anomaly: the
communication
anomaly
between the
under control
and the digital
meter
E2 Motor not
detected
E5 Electric
overload
protection:
Continuous
direct current
of the motor
over 6A for
more than 3s is
detected by the
under control
when
operating.
E6 Protection
against current
explosion:
The motor
circuit is
damaged by
voltage
anomaly or
motor anomaly.
E7 Safety lock falls
off.
The communication is blocked, please check each connection
point from the digital meter to the under control and change the
1.Please check the motor power line and reconnect it or replace
2.The motor could be damaged, please check and replace it if
1. Over load results in excessive current or some parts are
stuck and the motor could not operate normally.
2. Check the motor and replace it if needed.
3. Check the controller. If there's burnt smell, please replace it.
4. Check the specifications of the power supply. If it's not
compliant with the standard, please replace it with correct
1. Check the voltage. If it's not enough for normal operation,
please use correct power supply and try it again.
2. Check the controller. If there's peculiar smell, please
replace the controller.
3. Check the motor line. If it's not well connected, please fix it.
Connect the safety lock to the right position and make sure it
will not fall off easily again.
13
Fault Processing
Potential reasons:
broken lines.
Potential reasons:
if needed.
needed.
Potential reasons:
power supply.
Potential reasons: