Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Uni-Art SP4790
Summary of Contents for Uni-Art SP4790
- Page 1 All manuals and user guides at all-guidesbox.com SP4790 Wireless 900MHz Speaker...
-
Page 2: Package Includes
All manuals and user guides at all-guidesbox.com User’s Manual Please read before using the equipment INTRODUCTION This 900 MHz stereo wireless speaker system uses latest wireless technology that enables you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the system to any audio source such as Radio, TV, VCR, Hi-Fi and iPod/CD/MP3/VCD/DVD player. - Page 3 All manuals and user guides at all-guidesbox.com 2 x AC/DC 9V 1.2A Power Adaptor for Speakers 1 x 1.5M Long Audio Cable 1 x Short "Y-Cord" RCA Adaptor Cable.
- Page 4 All manuals and user guides at all-guidesbox.com COMPONENT IDENTIFICATION TRANSMITTER SPEAKER RECEIVERS Power LED Indicator Signal LED Indicator Audio In Channel Selector DC In For Transmitter Speaker Grill and Power/Signal LED Indicator Infrared Receiver Volume Up...
-
Page 5: Remote Control
All manuals and user guides at all-guidesbox.com Power On/Off Tune Volume Down REMOTE CONTROL Battery Compartment Battery Door Door Lock DC In For Speaker Left/Mono/Right Selection Power On/Off Volume Up Tune Volume Down Mute Lanyard Ring INSTALLATION TRANSMITTER Plug the supplied 8V AC/DC power adaptor in the DC jack located on the rear of the transmitter. Connect the supplied 8V AC/DC power adaptor to an electrical wall outlet. - Page 6 All manuals and user guides at all-guidesbox.com Having finished the above simple wiring, Signal LED glows when the transmitter detects audio input signal played from the source. SPEAKER RECEIVERS Remove the door of the battery compartment. Insert 6 pieces of ‘AA’ size ALKALINE batteries (not included) into the battery compartment with correct polarity under the speakers, then replace the door of battery compartment, or connect the provided AC/DC 9V Adaptor to the DC input jack under the speakers, then plug it to the wall AC outlet.
- Page 7 All manuals and user guides at all-guidesbox.com REMOTE CONTROL Remove the door of the battery compartment. Insert 2 x AAA 1.5V batteries (not included) into the compartment.
-
Page 8: Operation
All manuals and user guides at all-guidesbox.com OPERATION Turn on the audio source to which the transmitter is connected with. The Signal LED on transmitter will light up. Select a channel of the transmitter for best performance in your location. Select the L/M/R (Left/Mono/Right) selector under the speakers, one to L (Left) and the other to R (Right) for the best stereo reception. -
Page 9: Troubleshooting
All manuals and user guides at all-guidesbox.com NOTE : You should now be able to place the speakers freely from room to room without disruption. disruption should occur (signal breaks up), press the “TUNE” button under the speakers to maximize best reception. -
Page 10: Technical Specifications
All manuals and user guides at all-guidesbox.com TECHNICAL SPECIFICATIONS Transmission Mode : UHF stereo Carrier Frequency : 900 MHz Operation Voltage : Transmitter, AC/DC 8V 200mA Power Adaptor Speaker, AC/DC 9V 1.2A Power Adaptor, or 6 X ‘AA’ size Alkaline Batteries (not included) Remote Control, 2 x AAA battery (not included) Frequency Response : 40Hz –... -
Page 11: Fcc Statement
All manuals and user guides at all-guidesbox.com FCC STATEMENT: FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.