Related Manuals for Uni-Art SP2790
Summary of Contents for Uni-Art SP2790
- Page 1 SP2790 900MHz Wireless Outdoor/Indoor Speakers System User’s Manual Please read before using the equipment...
- Page 2 INTRODUCTION This 900 MHz wireless speaker system uses latest wireless technology that enables you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the system to any audio source such as Radio, TV, VCR, Hi-Fi and CD/MP3/VCD/DVD player.
-
Page 3: Component Identification
COMPONENT IDENTIFICATION TRANSMITTER REMOTE CONTROL SPEAKER RECEIVERS... -
Page 4: Installation
INSTALLATION TRANSMITTER 1. Insert the antenna tube into the antenna wire. 2. Connect the supplied AC/DC power adaptor to an electrical wall outlet. 3. Plug the AC/DC power adaptor in the DC jack located on the rear of the transmitter. 4. -
Page 5: Operation
2. Press POWER button and turn the speakers ON. The POWER LED will light up in blue. Switch off the speakers by pressing the POWER button on the speaker, and the LED will be off. OPERATION 1. Turn on the audio source (TV or audio component) to which the transmitter is connected with. - Page 6 reception. If you hear interference from other components, switch on the channel control of transmitter, and then move the speakers to other free location. You can re-adjust the tuning control by moving it either channel 1 , 2 or 3 of the transmitter, then pressing “AUTO TUNE”...
-
Page 7: Technical Specifications
DISTORTED Press the “AUTO TUNE” button on the speakers until matching the frequency of the transmitter. Change the position of the channel selector on the transmitter. You must then press the “AUTO TUNE” button on the speakers. Battery capacity is too low. Replace with the new battery. Ensure the volume level of speakers is adjusted properly. - Page 8 WARNING : MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE SERVICE SIGNALS PROHIBITED UNDER FCC RULES AND FEDERAL LAW. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.