Advertisement
to be added, the only icon will be for
1.3 Add Scanner scree.
1.3.1 Double click the
The
Add Scanner
1.3.2 Complete the
1.3.3 Enter the serial number of the scanner.
If the number is not accepted, you may need to update your linearization files.
1.3.4 Click
1.4 Connection screen.
1.4.1 Check the box for
This indicates that the scanner uses a NetLinc interface for connection and will
not require the TLAser400™ card.
1.4.2 Click
This is the new screen. It contains three fields:
.
NetLinc Serial Number
NetLinc Scanner IP Address
from TotalVu is made. The IP address for the NetLinc is not saved. You do not need match this
IP address with the NetLinc, as this field is authoritative.
If the NetLinc is connected to the
must acquire the IP address from a network administrator. The address should come from an IP
range reserved for Static IPs in the DHCP configuration.
If the NetLinc is connected directly to the PC with a crossover cable, before finishing this step
you will need to establish the Host IP address. The Scanner IP address must match the PC's
except for the last octet. In this case 10.10.10.x (where x = 2-n not to conflict with other devices)
is suggested. See
General Network
: Tells TotalVu which Ethernet interface of the computer to use by naming the
Host IP Address
associated IP address. To fill out this field, you must
crossover direct connection, you must first set a
10.10.10.1 as specified in
network with a separate wireless network.
NetLinc Serial Number
serial number is attached to the side of the unit. It starts with an x followed by 5 digits. For an
Internal NetLinc
this field is left blank as the serial number of the scanner from step 1 is
sufficient.
Complete the rest of the tabs as you would for a standard scanner. After connecting you will
need to
calibrate
the NetLinc using the standard method.
Add Scanner
wizard will open.
wizard as described in the following steps.
Add Scanner
or press
to move to the next screen.
Next
Enter
Scanner is connected as a NetLinc device
or press
to move to the next screen.
Next
Enter
: The NetLinc is assigned this IP address each time the connection
general network
and
Crossover
Crossover Direct
: This field is only used for an
Add Scanner.
icon.
NetLinc Scanner IP Address
as rather than a
Direct.
find your IP address
static IP Address
for this network. You may use
below. Ensure you do not confuse this Ethernet
External
NetLinc. The External NetLinc
.
,
Host IP Address
crossover
connection, you
. If you are using a
, and
Advertisement
