Page 1
-IMPORTANT NOTICE - RESIDENTIAL HOME USE ONLY. Not intended for public areas such as schools, churches, nurseries, day cares or parks Parts missing or damaged? Need assistance with assembly? Contact Us First! Please send your request to our central customer service email: welcome@petitseal.com One of our customer service agents will reply to you within 24 hours...
REV: 6-15-2022 Bridge Assembly and Installation Instructions Intended for children from ages 3 to 10 Model: 2005 WARNING: ASSEMBLY BY AN ADULT RETAIN (BOXES: 1007) THESE INSTRUCTIONS Swiss Walterli Kft. Petit Seal Simonffy utca 4-6, fszt. 41. Do not use this playset...
Warnings and Safe Play Instructions CONTINUOUS ADULT SUPERVISION REQUIRED. Most serious injuries and deaths on playground equipment have occurred while children were unsupervised! Our products are designed to meet mandatory and voluntary safety standards. Complying with all warnings and recommendations in these instructions will reduce the risk of serious or fatal injury to children using this play system.
Instructions for Proper Maintenance Your Petit Seal Playset is designed and constructed of quality materials with your child's safety in mind. As with all outdoor products used by children, it will weather and wear. To maximize the enjoyment, safety and life of your Play Set, it is important that you, the owner, properly maintain it.
Page 5
Playground Surfacing Materials Section 4 of the consumer product safety commission’s outdoor home playground safety handbook Select Protective Surfacing One of the most important things you can do to reduce the likelihood of serious head injuries is to install shock-protective surfacing under and around your play equipment.
Assembly Information Tools Required Robertson Drive Tape Measure Open End Wrench 8’ (2.4m) Step Ladder Carpenters Level (Included) 7/16" (11mm) & 1/2" (13mm) Safety Glasses Ratchet with extension Carpenters Square Adjustable Wrench Adult Helpers Claw Hammer Drill Bits (up to 3/8” (10mm) 7/16"...
Page 7
About our wood Petit Seal Play Systems uses only premium playset lumber, ensuring the safest product for your children’s use. Although we take great care in selecting the best quality lumber available, wood is still a product of nature and susceptible to weathering which can change the appearance of your set.
Page 8
OCCUPANTS / WEIGHT LIMITS / TOTAL WEIGHT / FALL HEIGHT Petit Seal recommends that the weight limits for all components must not be exceeded. Failure to adhere to these and other safety guidelines could result in damage to the playset and/or serious injury.
Page 9
Refer to the Safety Use Zone for the playset bridge attaches to Safety Zone Playset Playset Safety Zone Units: Feet/Meters Refer to the Safety Use Zone for the playset bridge attaches to Outside Inside Deck Units: Inches/Centimeters Ground Bridge Safety The minimum Safety Use Zone extends no less than 6’...
Page 10
WOOD IDENTIFICATION This space intentionally left blank...
Page 11
BRIDGE HARDWARE LISTING (Fasteners are shown full size) X8 - Hex Bolt - ⁵⁄₁₆ x 1,25” (486) X9 - ³⁄₈ Lock Washer X18 - ⁵⁄₁₆ Lock Washer (534) (420) X8 - Wafer Head Bolt - ⁵⁄₁₆ x 1,00” (533) X24 - ⁵⁄₁₆ Flat Washer (419) X4 - #8 x 3,00”...
Page 12
BRIDGE DECK Flush Flush to ends Flush of 226 #8 x 1.75 Wood Screw X8 Flush to edge at both ends of 228 Maintain width measurement shown at BOTH ends then attach as shown Step 1 - Place all 228 Deck Boards evenly spaced onto frame, then attach to frame Flush #8 x 1.75 Wood Screw X76...
Page 13
Bracket 311 X4 BRIDGE DECK Turn deck over to attach (4) brackets #8 x .75 Truss Head Screw X8 At each corner Step 1- Attach 311 using: ⁵⁄₁₆ x 1.25 Hex Bolt X4 ⁵⁄₁₆ Lock Washer X4 ⁵⁄₁₆ Flat Washer X4 Step 2 - Make sure 311 Bracket ⁵⁄₁₆...
Page 14
ATTACH TO PLAYSETS Notes: 1. The attachment method shown is the same for these playsets: - Play Deck XXL - Swing Set Deluxe + Play Deck - Refer to pages showing attachment to these playsets. Deck will be flush to playset decks Rails are flush to Do not attach balusters (111) playset rails...
Page 15
ATTACH TO PLAYSETS Rails flush to playset rails Rails must be inline with lower bridge rails at (4) corners Rail surfaces inline with each other Step 3 - Attach the four brackets to the rail ⁵⁄₁₆ x 1.00 Wafer Head Bolt X4 ³⁄₈...
Page 16
ATTACH TO PLAYSETS Balusters are flush at top of bridge rails #8 x 1.38 Wood Screw X96 End (4) balusters are flush to playset rails 2.86 [7.3] Space between all balusters 2.86 [7.3] Space between all balusters GO TO STEPS 10 AND 11 FOR THE PLAYSET THE BRIDGE ATTACHES TO Parts Required: 1.
Page 17
ATTACH TO TO SWING SET DELUXE Notes: 1. The Bridge can be safely be installed at the locations shown. 2. Do not install at the location noted NO BRIDGE. 3. The wall balusters (Part 111) will be removed at the bridge openings. 4.
Page 18
ATTACH TO TO SWING SET DELUXE Notes: 1. The Bridge can be safely be installed at the locations shown. 2. Do not install at the location noted NO BRIDGE. 3. The wall balusters (Part 111) will be removed at the bridge openings. 4.
Page 19
ATTACH TO TO SWING SET DELUXE LADDER ROOF OUTLINE SLIDE For the Ladder and Slide sides THE BRIDGE IS INSTALLED Center Bridge between uprights THE SAME ON EITHER SIDE and install beginning at Step 5 AS SHOWN No balusters (Part 111) in Bridge openings...
Page 20
ATTACH TO TO SWING SET DELUXE TABLE ROOF OUTLINE Center Bridge between uprights and install beginning at Step 5 Part 111 No balusters (Part 111) in Bridge openings Flush USE (2) OF THE EXISTING BALUSTERS (PART 111) AND INSTALL ON BOTH SIDES OF THE BRIDGE FLUSH TO THE BRIDGE BALUSTER.
Page 21
ATTACH TO TO SWING SET DELUXE SWING BEAM ROOF OUTLINE Center Bridge between uprights and install beginning at Step 5 3.00 [7.6] All spaces between balusters Flush After installing Part 111 against bridge, install (5) more Part 111 with 3.00 [7.6] spacing between each.
Page 22
ATTACH TO TO SWING SET DELUXE SWING BEAM ROOF OUTLINE 3.00 [7.6] All spaces between balusters Center Bridge between uprights and install beginning at Step 5 Flush After installing Part 111 against bridge, install (5) more Part 111 with 3.00 [7.6] spacing between each.
Page 23
ATTACH TO TO DECK XXL BETWEEN UPRIGHTS PART 100 Center Bridge between uprights and install beginning at Step 5 No balusters (Part 111) in Bridge openings Two end bridge balusters installed against upright Install ladder here Locate and install boards as shown in Deck XXL instruction...
Page 24
ATTACH TO TO DECK XXL TABLE Locate the bridge rail 6.00 [15.2] from end 6.00 [15.2] of rail and install beginning at Step 5 1.00 [2.5] Install baluster from 1.00 [2.5] Install baluster from Bridge baluster Bridge baluster No balusters (Part 111) in Bridge openings 3.00 [7.6] Space Install (6) balusters...
Page 25
ATTACH TO TO DECK XXL TABLE Locate the bridge rail 6.00 [15.2] from end 6.00 [15.2] of rail and install beginning at Step 5 3.00 [7.6] Space 1.00 [2.5] Install baluster from 1.00 [2.5] Install baluster from Bridge baluster Bridge baluster Install (6) balusters with a 3.00 [7.6] space between each along...
Page 26
ATTACH TO TO DECK XXL TABLE Locate the bridge rail 6.00 [15.2] from end 6.00 [15.2] of rail and install beginning at Step 5 3.00 [7.6] Space 1.00 [2.5] Install baluster from 1.00 [2.5] Install baluster from Bridge baluster Bridge baluster Install (6) balusters with a 3.00 [7.6] space between each along...
Page 27
ATTACH TO TO DECK XXL ROCKWALL Center Bridge between uprights and install beginning at Step 5 No balusters (Part 111) in Bridge openings Locate and install boards Two end bridge balusters as shown in Deck XXL installed against upright instruction Flush When Bridge is over the Rockwall, make a wall using the rockwall boards...
Page 28
ATTACH TO TO DECK XXL SLIDE Locate the bridge rail 1.00 [2.5] from 1.00 [2.5] upright and install beginning at Step 5 No balusters (Part 111) in Bridge openings Space (3) balusters evenly between bridge and upright...
Page 29
ATTACH TO TO DECK XXL Swing Beam cannot be located on same side as Bridge SWING BEAM Locate the bridge rail 6.00 [15.2] from end 6.00 [15.2] of rail and install beginning at Step 5 1.00 [2.5] Install baluster from Bridge baluster 1.00 [2.5] Install baluster from 3.00 [7.6] Space...
Page 30
ATTACH TO TO DECK XXL Swing Beam cannot be located on same side as Bridge SWING BEAM Locate the bridge rail 6.00 [15.2] from end 6.00 [15.2] of rail and install beginning at Step 5 1.00 [2.5] Install baluster from 1.00 [2.5] Install baluster from Bridge baluster Bridge baluster...
Excludes all, surface cracks, knotholes and knots in the wood components. A note about wood: The wooden components in your Swiss Walterli's (dba. PETIT SEAL) swing set will have natural imperfections such as surface cracks, knots and knot holes. These are natural characteristics of wood. Natural imperfections such as these that do not affect structural integrity are expressly excluded from Warrant.